12-08-19, 12:45 PM
Hello,
We have recently installed Real Vision 3D with the Port/Starboard sensors with the 20 degree dead rise.
We have not used it a lot yet, but initial tests seemed ok, and we could see the bottom return in RV3D.
During the weekend several times I could not get a bottom return on the RV3D - however it was returning fish, and the sonar mode was also functioning clearly.
This was in about 10m of water. I tried both auto and manually adjusting the gain and surface clutter settings, but to no avail.
What steps can I take to trouble shoot this?
Thanks,
Watsala
We have recently installed Real Vision 3D with the Port/Starboard sensors with the 20 degree dead rise.
We have not used it a lot yet, but initial tests seemed ok, and we could see the bottom return in RV3D.
During the weekend several times I could not get a bottom return on the RV3D - however it was returning fish, and the sonar mode was also functioning clearly.
This was in about 10m of water. I tried both auto and manually adjusting the gain and surface clutter settings, but to no avail.
What steps can I take to trouble shoot this?
Thanks,
Watsala