01-17-20, 04:17 PM
01-19-20, 07:22 PM
Hello Grayson,
Raymarine AIS transceivers don't output position data by default. It is possible to enable output via NMEA0183 in the ProAIS2 software but we recommend not doing so, in part because this GPS source doesn't take part in our 'multiple data source selection' process. We would always recommend using a dedicated navigational GPS receiver.
Regards,
Tom
Raymarine AIS transceivers don't output position data by default. It is possible to enable output via NMEA0183 in the ProAIS2 software but we recommend not doing so, in part because this GPS source doesn't take part in our 'multiple data source selection' process. We would always recommend using a dedicated navigational GPS receiver.
Regards,
Tom