01-24-20, 12:03 PM
Good day all,
I have recently installed a new Evolution autopilot onto an existing system to replace a malfunctioning SMARTPILOT X30. The pilot system is as follows:
-EV-1 sensor
-ACU-400
-Existing P70 pilot head at nav station
-Existing ST6001 pilot head on flybridge
It is linked to the network with other instruments.
I have managed to get wind data to the pilot no problems and I can control the pilot from the e120w ( there are 2 of these in the network) with no issues.
My issue is however:
When I want to set a waypoint on the E120W and get the pilot to track to that waypoint ( or route or cursor for that matter) I get the following errors ( in no particular order): 'Route complete' and 'No navigation data'.
My original thought was that the deviation might be incorrect but it was found to be at 4 degrees ( similar to the 5 degrees on the E120W).
Any ideas?
Many thanks,
Rom
I have recently installed a new Evolution autopilot onto an existing system to replace a malfunctioning SMARTPILOT X30. The pilot system is as follows:
-EV-1 sensor
-ACU-400
-Existing P70 pilot head at nav station
-Existing ST6001 pilot head on flybridge
It is linked to the network with other instruments.
I have managed to get wind data to the pilot no problems and I can control the pilot from the e120w ( there are 2 of these in the network) with no issues.
My issue is however:
When I want to set a waypoint on the E120W and get the pilot to track to that waypoint ( or route or cursor for that matter) I get the following errors ( in no particular order): 'Route complete' and 'No navigation data'.
My original thought was that the deviation might be incorrect but it was found to be at 4 degrees ( similar to the 5 degrees on the E120W).
Any ideas?
Many thanks,
Rom