02-02-20, 03:55 AM
Hello,
my setup on board is a ST6001 autopilot instrument, S2/400 course computer (assumed), flux-gate compass and hydraulic steering.
Would the autopilot be fully functional including the calibration of the fluxgate, if I replace the ST6001 with a new instrument?
Will the eS78 MFD autopilot support wwork, if I replace the instrument only?
Course Computer: As I have no documents about the course computer, I am not really sure which type of course computer I have. The system was purchased 2004, the PCB is labeled with "C/Comp 400 23928".
Thank you in advance.
Kind regards,
Ralf
my setup on board is a ST6001 autopilot instrument, S2/400 course computer (assumed), flux-gate compass and hydraulic steering.
Would the autopilot be fully functional including the calibration of the fluxgate, if I replace the ST6001 with a new instrument?
Will the eS78 MFD autopilot support wwork, if I replace the instrument only?
Course Computer: As I have no documents about the course computer, I am not really sure which type of course computer I have. The system was purchased 2004, the PCB is labeled with "C/Comp 400 23928".
Thank you in advance.
Kind regards,
Ralf