02-16-20, 01:21 PM
Hello,
I have an anomaly on the screen of my first gen C80, the one with the five soft keys below the display. There's a white label overlaid on the chartview with the uppercase letter B and a range and bearing.
The range and bearing do not change as the boat moves. It is locked to this location or to the center of the screen. I was sailing with guests and didn't check for this but it is fixed to the location where it is now. Not only do I not know what it is but I also can't get rid of it.
Moving the cursor and changing to find ship/cursor has no effect.
Radar is in standby no target being tracked.
Not tracking to any waypoints (range and bearing don't change anyway) I travelled 14 miles and the range and bearing stayed the same.
I don't have AIS and the AIS layer is off.
Declutter doesn't remove it and it can't be selected and viewed with the cursor like a buoy or waypoint. No information is displayed.
Local or System has no effect
Here's the kicker: It's only on the chart on shared multi screens. It stays on the screen if I pop it out to full screenwith the active buttong BUT if I go to the non multi info view with the soft buttons it isn't displayed.
Cycling the power doesn't clear it.
Is it a glitch? Do I have to reset and re-set up the whole unit?
I'm having trouble getting an attached photo to display in this post. If one isn't seen. I could also use help with this. I don't see a FAQ for posting photos.
I have an anomaly on the screen of my first gen C80, the one with the five soft keys below the display. There's a white label overlaid on the chartview with the uppercase letter B and a range and bearing.
The range and bearing do not change as the boat moves. It is locked to this location or to the center of the screen. I was sailing with guests and didn't check for this but it is fixed to the location where it is now. Not only do I not know what it is but I also can't get rid of it.
Moving the cursor and changing to find ship/cursor has no effect.
Radar is in standby no target being tracked.
Not tracking to any waypoints (range and bearing don't change anyway) I travelled 14 miles and the range and bearing stayed the same.
I don't have AIS and the AIS layer is off.
Declutter doesn't remove it and it can't be selected and viewed with the cursor like a buoy or waypoint. No information is displayed.
Local or System has no effect
Here's the kicker: It's only on the chart on shared multi screens. It stays on the screen if I pop it out to full screenwith the active buttong BUT if I go to the non multi info view with the soft buttons it isn't displayed.
Cycling the power doesn't clear it.
Is it a glitch? Do I have to reset and re-set up the whole unit?
I'm having trouble getting an attached photo to display in this post. If one isn't seen. I could also use help with this. I don't see a FAQ for posting photos.