02-28-20, 03:27 PM
Hi all
I have two C90W’s with pre-installed charts, one in the cabin and the other on the fly bridge. The cabin unit is set as the master but when used without the fly unit switched on shows considerably less detail no contours or additional wrecks. However when both units are on all contours, wrecks and detail are shown. I have done a reset on the cabin unit with no change. Software on both units is v2.35
Settings
Safety contours = 66ft
Depth contour = All
Additional wrecks = on
Any suggestions pls
I have two C90W’s with pre-installed charts, one in the cabin and the other on the fly bridge. The cabin unit is set as the master but when used without the fly unit switched on shows considerably less detail no contours or additional wrecks. However when both units are on all contours, wrecks and detail are shown. I have done a reset on the cabin unit with no change. Software on both units is v2.35
Settings
Safety contours = 66ft
Depth contour = All
Additional wrecks = on
Any suggestions pls