04-28-20, 11:38 AM
Chuck,
That’s fantastic, thank you.
If I understand it correctly, to do a wired connection from my sailboat mast to my pod mounted Axiom Pro in the cockpit I will need the following to be connected in this order:
Quantum Digital Doppler Radar
A80308 (Y-Adapter Cable)
A55081D (10m Radar Extension Cable)
A80228 (10m Digital Radar Cable, Power and Ethernet)
SPLIT, with power going to my switched 12V power circuit
A80162* (Raynet(M) to Raynet(M) adapter cable
Supplied Raynet (F) to Raynet (F) (supplied w/Radar when purchased)
Axiom Pro
*In the cited knowledge base article you referenced (https://forum.raymarine.com/showthread.php?tid=421) it is recommend to use an A80160 (Binnacle mounted pod/no network switch) however I believe A80162 is the correct joiner in this case.
Thank you.
That’s fantastic, thank you.
If I understand it correctly, to do a wired connection from my sailboat mast to my pod mounted Axiom Pro in the cockpit I will need the following to be connected in this order:
Quantum Digital Doppler Radar
A80308 (Y-Adapter Cable)
A55081D (10m Radar Extension Cable)
A80228 (10m Digital Radar Cable, Power and Ethernet)
SPLIT, with power going to my switched 12V power circuit
A80162* (Raynet(M) to Raynet(M) adapter cable
Supplied Raynet (F) to Raynet (F) (supplied w/Radar when purchased)
Axiom Pro
*In the cited knowledge base article you referenced (https://forum.raymarine.com/showthread.php?tid=421) it is recommend to use an A80160 (Binnacle mounted pod/no network switch) however I believe A80162 is the correct joiner in this case.
Thank you.