Raymarine forum

Hi,

I want to connect the Raystar125 to the NMEA0183. The manual is not clear as it does not show a possibility of the GPS with only NMEA OUT + and the plotter with NMEA IN + and -.
I understand I need 12V and ground/0 for the antenna and connect the 2 not used wires to ground. But what do I connect to the IN - on the plotter?

Welcome to the Raymarine Forum

Please see the chart below addressing how to interface a Raystar 125 GPS Sensor to c/e-Series MFD.

So as I understand correctly, output from E95 connected to input from Raystar 125 and output Raystar 125 connected to input E95. Sounds logic but differs from earlier NMEA013 where you use NMEA IN the + and the -. Am I right?

In connect the brown and black from the Raystar 125 to GND 0V. DO I also have to do that with green and brown from the E95 or can I leave them disconnected?

Marien,

Q1. As I understand correctly, output from E95 connected to input from Raystar 125 and output Raystar 125 connected to input E95.
A1. Correct.

Q2. In connecting the brown and black from the Raystar 125 to GND 0V. DO I also have to do that with green and brown from the E95?
A2. Yes.

It works. Thanks