04-07-20, 10:48 AM
The cable for the flux gate compass was unknowingly severed and I powered up the system to find a no comp alert and also a no pilot alert. After finding the break in the cable I then spliced and the no comp went away and the autopilot began working but I still get a brief no pilot message when I power back up.It then it switches to the magnetic screen and does a standard startup and appears to function. I have tried pushing standby to clear the “no pilotâ€alert but it continues to appear briefly when switching on the computer at the circuit panel. is this normal and I just don’t remember this sequence? or is there a way to clear this alert? Furthermore the alert only appears when powering from the main breaker power and not if I power down and power up-from the controller leaving the computer powered up.in other word the alert only appears when turning on the computer after a complete power down