Raymarine forum

Hello,

I am trying to set a shallow depth alarm at 10m.
Despite numerous attempts, pressing offset and reset simultaneously, I am not able to change the shallow alarm setting.

Changing the shallow anchor alarm by pressing offset and reset simultaneously is not a problem, but I am not able to select a shallow anchor alarm setting greater than 6.0m.

Thanks

Adam

Welcome to the Raymarine Forum Adam,

Has the ST60+ Depth instrument been installed as a depth repeater or as a depth master? If the ST60+ Depth instrument has been installed as a depth master, then upon inspecting the back side of the instrument, you will find that the depth transducer has been interfaced to its terminals. If however, the ST60+ Depth instrument has been installed as a repeater, then these alarms will need to be configured on the device which is supplying the system with depth data.

The ST60+ Depth instrument been installed as a depth master.
The transducer cables are connected at the back of the instrument.

I also checked the intermediate calibration settings and the instrument is set as Master.
The software version is 1.0

Hi Adam,

Have you checked the Shallow alarm lock feature has been turned off? There is a lock setting in the user calibration menu?

I am not sure why the shallow anchor alarm cannot be increased, however, try to adjust this after the lock is removed from the shallow alarm.

Regards

Derek