04-24-20, 11:27 AM
I have a EV-100 autopilot with a P70s control head installed and intergrated to a Axiom MFD.
Is there a user selection input to change the auto tack function (+_1 +_10 buttons pushed together) value from 90 degrees to another value say between 90 and 100 degrees? If so what procedure is used to do this? If not so could this be a future software updates?
I single hand quite a bit and currently use the auto tack function quite a bit with additional a series of 1 or 10 degree adjustment all while attending to jib sheets etc.
Thanks.
Is there a user selection input to change the auto tack function (+_1 +_10 buttons pushed together) value from 90 degrees to another value say between 90 and 100 degrees? If so what procedure is used to do this? If not so could this be a future software updates?
I single hand quite a bit and currently use the auto tack function quite a bit with additional a series of 1 or 10 degree adjustment all while attending to jib sheets etc.
Thanks.