05-09-20, 10:59 AM
My boat has the smartpilot S1 installed with the fluxgate, rudder position but the hydrolic motor is bad. I just upgraded to the Axiom 9rv.
I would like to know if the smartpilot with NO head can connect to the Axiom via nmea0183 or Seatalk 1 into my nmea2k backbone?
The reason for this question is I would rather replace the pump and use the axiom to control the autopilot instead of spending 2k on a replacement/upgraded autopilot.
so I guess its 2 questions
1 - Will the S1 interface with my axiom over nmea2k or ST1 and if so what cables will i need
2 - Can i run the S1 just with the Axiom 9rv or do I need a new head unit and if not which head units work with it
Thanks
Bill
I would like to know if the smartpilot with NO head can connect to the Axiom via nmea0183 or Seatalk 1 into my nmea2k backbone?
The reason for this question is I would rather replace the pump and use the axiom to control the autopilot instead of spending 2k on a replacement/upgraded autopilot.
so I guess its 2 questions
1 - Will the S1 interface with my axiom over nmea2k or ST1 and if so what cables will i need
2 - Can i run the S1 just with the Axiom 9rv or do I need a new head unit and if not which head units work with it
Thanks
Bill