12-10-16, 12:13 PM
I'm upgrading my A/H from a Raymarine 150/400 to the Evolution 1 with the ACU-200. I notice there is a Ferrite Supression module on the power line? Do I need this for my new unit? Any harm in leaving it there?
Thanks
Thanks
12-10-16, 12:13 PM
12-13-16, 02:01 PM
Suppression ferrites
Raymarine cables may be fitted with suppression ferrites. These are important for correct EMC performance. Should a ferrite be removed, then the RF emissions produced by the product may cause RF interference with other products (ex. VHF radios, stereo receivers, etc.). If a ferrite has to be removed for any purpose (e.g. installation or maintenance), it must be replaced in the original position before the product is used.
Should a ferrite not be packaged with the product, then it should not be necessary to install a ferrite on the cable which will be powering the product.
Raymarine cables may be fitted with suppression ferrites. These are important for correct EMC performance. Should a ferrite be removed, then the RF emissions produced by the product may cause RF interference with other products (ex. VHF radios, stereo receivers, etc.). If a ferrite has to be removed for any purpose (e.g. installation or maintenance), it must be replaced in the original position before the product is used.
Should a ferrite not be packaged with the product, then it should not be necessary to install a ferrite on the cable which will be powering the product.