Raymarine forum

I pulled the wording below from a previous post. Is R70003 cable the one to use to transmit the Plotter Feed to a TV monitor. What plug is on the Monitor end, HDMI? or Phone type plug


Video Output: The R70003 e-Series Accessory Video Cable may be used to interface a 9” and larger e-Series MFDs to a monitor or TV supporting 720P @ 60Hz. The gS-Series MFDs as well as the 9” and larger e-Series MFDs feature a HDMI port to permit the MFD to be interfaced to a monitor or TV to repeat the MFD’s screen image.

Welcome to the Raymarine Technical Forum gkastendike,

According Section 3 (page 20) of the a/c/e-Series MFD Installation Guide, the Video output connector of the R70003 e-Series Accessory Video Cable is 15 pin D-Type (VGA Style):
- a9x / a12x MFDs = 15 pin D-Type connector (VGA Style)
- e9x / e12x / e165 MFDs = 15 pin D-Type connector (VGA Style)
Connecting above listed MFDs to a TV's HDMI socket will require the R70003 cable and a third party 15 pin D-Type to HDMI adapter.

The video output connector of the A80218 gS-Series Video Output Cable for the eS9x / eS12x MFDs and gS Series MFDs is HDMI.

George,

Please see the private message sent to you earlier this afternoon.