Raymarine forum

Hello,

We have a costumer with an E80 Multifunction display and we need to know if the seatalk 2 port is working, where can we find the pinout of this port? I found the NMEA 0183 and Seatalk pinout in the instalation manual, but Seatalk 2 is missed!

A few more cuestions:

Is Seatalk 2 fully compatible with Seatalk NG?

Is necessary to power the Seatalk 2 port from the network in order it to work?

Can GPS, autopilot, sounder and anemometer be connected to de E80 throught the Seatalk 2 port?

Thanks in advance,

Martin Sivolella
Aeromarine S.A.

Welcome to the Raymarine Forum Martin,

Please see the image below detailing the the E-Series Classic MFD's SeaTalk2/NMEA 2000 plug.



When operating with the latest available Raymarine product software updates, E-Series Classic MFDs feature SeaTalkng/NMEA2000 support via the MFD's SeaTalk2/NMEA 2000 socket. Should one have a system featuring a ST290 DPU, then it is recommended that the DPU be interface to the system as a SeaTalk device via a SeaTalk to SeaTalkng Converter. With the exception of AIS transceivers, the E-Series Classic MFD will support operation via SeaTalkng with other Raymarine products featuring a SeaTalkng communications interface. With respect to third party products other than engine systems, NMEA 2000 communications with E-Series Classic MFDs may occur for third party NMEA 2000 devices for which Raymarine offers a corresponding product.

Thanks for your help Chuck.

Regards,

Martin

You're welcome.