06-16-18, 03:16 PM
06-18-18, 03:26 PM
Welcome to the Raymarine Forum Doug,
As vectors are associated the vessel icon, holding one's finger pressed atop the vessel icon within the Chart application will cause a vessel icon context menu to be displayed. From this context menu, the operator may select to display the COG (vessel must be moving) and/or Heading (system must be interfaced to a heading source) vectors as well as to configure the length of these vectors.
As vectors are associated the vessel icon, holding one's finger pressed atop the vessel icon within the Chart application will cause a vessel icon context menu to be displayed. From this context menu, the operator may select to display the COG (vessel must be moving) and/or Heading (system must be interfaced to a heading source) vectors as well as to configure the length of these vectors.
06-19-18, 09:24 AM
Chuck, THANKYOU.
Where, or in what manual, would point this out?
Can you provide a link?
Where, or in what manual, would point this out?
Can you provide a link?
06-19-18, 09:54 AM
Oregoncme,
This may be found within the Vessel Details section Chapter 8.1 Chart app overview (more specifically page 96) of the LightHouse 3.4 Advanced Operation Instructions.
This may be found within the Vessel Details section Chapter 8.1 Chart app overview (more specifically page 96) of the LightHouse 3.4 Advanced Operation Instructions.
06-19-18, 02:43 PM
You are right on the money Chuck!
Thank you very much!
Thank you very much!
06-19-18, 03:55 PM
You're welcome.