10-22-18, 09:29 AM
My 'new' sailboat has B&G 'Network' instruments (wind/speed/depth/data/repeater) daisy chained with Network cables. This can output NMEA 0183 v1.5
Also have B&G 'Network' Pilot connected to the system, this also can receive NMEA 0183 v1.5
NASA AIS ENgine 3 (2017), I believe this transmits NMEA0183 HS; this is connected at present to an older standalone plotter.
I have a new es128 MFD which I would like to interface to the above so that the MFD receives/displays wind/speed/depth/heading and AIS data, and hopefully also use this to utilise the collision avoidance and layline features; and also so the MFD sends waypoint and route info to the pilot to follow when in 'NAV' mode. I realise that the autopilot control feature of the MFD will not be available.
I also have dsc vhf but this needs mmsi reprogramming so this can wait till a later date.
Could you advise the best/most cost effective way to achieve this-do I need multiplexers/converters etc., or can I do this simply using the NMEA cables combined in the es 128 power/video/NMEA cable? If so, can you advise what connections should be made.
I am a bit familiar with the single ended/differential variation of NMEa v1.5 and v2, but no expert!
Also have B&G 'Network' Pilot connected to the system, this also can receive NMEA 0183 v1.5
NASA AIS ENgine 3 (2017), I believe this transmits NMEA0183 HS; this is connected at present to an older standalone plotter.
I have a new es128 MFD which I would like to interface to the above so that the MFD receives/displays wind/speed/depth/heading and AIS data, and hopefully also use this to utilise the collision avoidance and layline features; and also so the MFD sends waypoint and route info to the pilot to follow when in 'NAV' mode. I realise that the autopilot control feature of the MFD will not be available.
I also have dsc vhf but this needs mmsi reprogramming so this can wait till a later date.
Could you advise the best/most cost effective way to achieve this-do I need multiplexers/converters etc., or can I do this simply using the NMEA cables combined in the es 128 power/video/NMEA cable? If so, can you advise what connections should be made.
I am a bit familiar with the single ended/differential variation of NMEa v1.5 and v2, but no expert!