12-17-18, 04:02 AM
Hello,
After disassembling the instruments for more than a week to move them I alarm "No pilot" on the ST6002 control unit. In addition, I can not enter the "Dealer CAL" menu to reset the driver settings (the "CAL?" Screen does not appear after pressing "Auto" and the "-1" keys and +1) do not allow entering the menu modifying the parameters of the "Dealer CAL" menu.
Here is the installation:
- ST6002 control unit (pilot display)
- SmartPilot S2 Calculator
- Power unit: linear electric motor type 1
- Rubber sensor
- Fluxgate Compass.
- ST60 Tridata and wind mode
Thank you for telling me why I can not get into the "Dealer CAL" menu?
Sorry for my poor English…
cordially.
After disassembling the instruments for more than a week to move them I alarm "No pilot" on the ST6002 control unit. In addition, I can not enter the "Dealer CAL" menu to reset the driver settings (the "CAL?" Screen does not appear after pressing "Auto" and the "-1" keys and +1) do not allow entering the menu modifying the parameters of the "Dealer CAL" menu.
Here is the installation:
- ST6002 control unit (pilot display)
- SmartPilot S2 Calculator
- Power unit: linear electric motor type 1
- Rubber sensor
- Fluxgate Compass.
- ST60 Tridata and wind mode
Thank you for telling me why I can not get into the "Dealer CAL" menu?
Sorry for my poor English…
cordially.