02-02-19, 01:39 PM
Hello,
I replaced several older Raymarine products (SL70C MFD, Raydome, & Raystar 125 GPS sensor) with new Garmin units (942xs MFD, 18xHD Dome, and Fusion radio/remote).
I still want to use my existing Raymarine Auto Pilot ACU200, P70R, A67 MFD, and ICOM M400BB.
I am curious if the attached network schematic is correct?
Q1. Is the power from the ACU200 enough to power the network or should I use the independent Garmin power cable (yellow) and turn the power from the ACU200 off?
Q2. Is the NMEA 2000 to STng cable properly connected? Wasn’t sure if I can use the blue backbone port or if I have to use a white spur cable port.
Q3. Is the NMEA 0183 for my ICOM M400BB hooked up properly?
Thanks in advance for the input.
I replaced several older Raymarine products (SL70C MFD, Raydome, & Raystar 125 GPS sensor) with new Garmin units (942xs MFD, 18xHD Dome, and Fusion radio/remote).
I still want to use my existing Raymarine Auto Pilot ACU200, P70R, A67 MFD, and ICOM M400BB.
I am curious if the attached network schematic is correct?
Q1. Is the power from the ACU200 enough to power the network or should I use the independent Garmin power cable (yellow) and turn the power from the ACU200 off?
Q2. Is the NMEA 2000 to STng cable properly connected? Wasn’t sure if I can use the blue backbone port or if I have to use a white spur cable port.
Q3. Is the NMEA 0183 for my ICOM M400BB hooked up properly?
Thanks in advance for the input.