03-31-19, 04:20 PM
I'm installing an ACU-200 / EV-1 sail autopilot. During installation I found that the electrical connector provided for the "dedicated drain wire", a blade style connector, doesn't fit AWG 10 wire. It's smaller and seems to be perhaps AWG 14. But the manual recommends AWG 10 to 8 for the ACU-200.
I'm using AWG 10 and had to strip back some of the strands and jam it into the connector. Is this normal? Perhaps the wrong connector was packaged with this?
I'm using AWG 10 and had to strip back some of the strands and jam it into the connector. Is this normal? Perhaps the wrong connector was packaged with this?