05-24-19, 08:00 AM
I recently replaced a B744V transducer that feeds an Es127 MFD. I had this transducer installed during a recent bottom job without checking the connections and when we went to hook it up found we had the wrong connector. The old transducer was a
31-668-2-02 and we installed a 31-669-1-01. Is it possible to cut and splice these cables? Any other suggestions without pulling the boat again?
31-668-2-02 and we installed a 31-669-1-01. Is it possible to cut and splice these cables? Any other suggestions without pulling the boat again?