I have two Dragonfly units on my boat and a master power switch at the battery. When I turn on power at the switch one Dragonfly begins the start-up sequence and the other remains off, until I press its power button. I want both units to remain off until I manually turn them on, but I do not find an option for this or a solution via searches.
If it matters, the auto-boot unit is a df4 and the one than works as desired is a 5.
Thanks in advance for the help.
John,
Like most Raymarine products featuring a power button, the Dragonfly displays support a last power state memory feature, the equipment may be switched ON/OFF from a single location (i.e. the breaker/switch panel), eliminating the need to switch ON/OFF equipment via each product's POWER button. This can be especially convenient in larger systems.
The last power state memory feature of Dragonfly displays functions as follows:
- should the product be in the ON state and should the circuit supplying the product be de-energized, then the product will return to the ON state when the circuit is re-energized.
- should the product in the OFF state and should the circuit supplying the product be de-energized, then the product will remain in the OFF state when the circuit is re-energized. Pressing the POWER button of the product will return it to the ON state.
That did not work for me... any other ideas? This is not a big deal but if it can be corrected it would be nice.
John,
Should one of the Dragonfly displays not have performed as I have stated, then it would indicate a problem with the display's circuitry, necessitating that the display be sent to
Raymarine’s Product Repair Center to be bench checked / serviced or that the display(s) be powered on/off via a conveniently located switch located at the helm or near the display.
Thanks again for your help.