06-20-19, 08:38 AM
I have a retractable ST800 depth/temp transducer, and what I believe is a P19 depth only transducer. They connect to an ST60+ tridata display.
Recently the depth is showing as ---. The speed and temp display properly. I checked the wiring and it seems fine, so I assume the problem is the depth transducer.
The difficulty is that the depth transducer is not retractable and so I would have to haul the boat to have it replaced.
I found (and ordered) a DST800 analog ST60+ compatible transducer which does depth, speed and temp in a single device, and I was planning to insert it into the sleeve that the ST but I found that it has a larger diameter (36mm) than the ST800 that it would replace (31mm). (Attached is a picture of the respective blanking inserts showing the different diameters).
Is anyone aware of a DST device with the 31mm diameter, or any other solution that I could implement without having to haul the boat?
Recently the depth is showing as ---. The speed and temp display properly. I checked the wiring and it seems fine, so I assume the problem is the depth transducer.
The difficulty is that the depth transducer is not retractable and so I would have to haul the boat to have it replaced.
I found (and ordered) a DST800 analog ST60+ compatible transducer which does depth, speed and temp in a single device, and I was planning to insert it into the sleeve that the ST but I found that it has a larger diameter (36mm) than the ST800 that it would replace (31mm). (Attached is a picture of the respective blanking inserts showing the different diameters).
Is anyone aware of a DST device with the 31mm diameter, or any other solution that I could implement without having to haul the boat?