07-15-19, 11:52 AM
I have two networked Axiom 12s and I am having a couple of slightly annoying issues:
1. The 2nd unit will freeze at boot up randomly (well at least I think randomly), usually at the picture of the lighthouse. If I cycle the power through the battery switch it still freezes unless I pause the cycle for for 5-10 seconds then it boots up like normal. Any thoughts?
2. On the second unit the power/brightness screen will popup quite a lot, even just sitting at the dock. I switched the power source and cord from the primary unit to the secondary unit. I did this to see if I had a electrical wiring issue (Primary unit has no issues). Primary unit was fine and secondary continued to act up. What I figured out was that if I change the brightness slightly either way the popup stopped... again any thoughts here?
All that being said I can typically resolve issues within a couple of minutes of startup. The systems are on all day and neither issue reappears so not really hampering me but if I could avoid it that would be great. Really love the system especial the auto acquire of targets...
Couple of additional notes:
- I have software version v3.9.46
- I did a soft and factory reset (a couple of times) on the both units after software upgrade
Thanks,
Jon
1. The 2nd unit will freeze at boot up randomly (well at least I think randomly), usually at the picture of the lighthouse. If I cycle the power through the battery switch it still freezes unless I pause the cycle for for 5-10 seconds then it boots up like normal. Any thoughts?
2. On the second unit the power/brightness screen will popup quite a lot, even just sitting at the dock. I switched the power source and cord from the primary unit to the secondary unit. I did this to see if I had a electrical wiring issue (Primary unit has no issues). Primary unit was fine and secondary continued to act up. What I figured out was that if I change the brightness slightly either way the popup stopped... again any thoughts here?
All that being said I can typically resolve issues within a couple of minutes of startup. The systems are on all day and neither issue reappears so not really hampering me but if I could avoid it that would be great. Really love the system especial the auto acquire of targets...
Couple of additional notes:
- I have software version v3.9.46
- I did a soft and factory reset (a couple of times) on the both units after software upgrade
Thanks,
Jon