08-17-19, 09:13 PM
I did something to the E120 chart plotter that told it to take control of the ST6002 autopilot. I guess it was “tracking†.
Since then the autopilot has been displaying an incorrect heading
And behaving erratically, sometimes it drifts to an incorrect heading and sometimes is radically changes direction of the boat. It is not trustworthy.
Not sure what screen or commands I was in when I told the e120 to control the autopilot. Where in the menu does it say that the autopilot controller is on or off?
E120 Menu
System setup
SYStem integration setup
Autopilot control disabled
this still does not fix the problem. what do i need to do here. it was working fine
until i did something to the E120.
Since then the autopilot has been displaying an incorrect heading
And behaving erratically, sometimes it drifts to an incorrect heading and sometimes is radically changes direction of the boat. It is not trustworthy.
Not sure what screen or commands I was in when I told the e120 to control the autopilot. Where in the menu does it say that the autopilot controller is on or off?
E120 Menu
System setup
SYStem integration setup
Autopilot control disabled
this still does not fix the problem. what do i need to do here. it was working fine
until i did something to the E120.