+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Thermal Cameras (/forumdisplay.php?fid=127)
+--- Thread: [CA] [CA11] M232 W/Axiom MFD's - no video (/showthread.php?tid=10838)
[CA11] M232 W/Axiom MFD's - no video - nmp427 - 03-27-20 05:04 PM
Hello,
So last year I installed a 232 and a couple Axiom 12's
Everything went well on the install, a couple times there would be no video from the thermal, I could pull the fuse and it would take off and work
I updated to the latest LH software last week, we go out last night and no image (I can still control the cam - pan/tilt)
I do my fuse trick 3 different times, no luck
Any ideas?
TIA
Nick
RE: [CA11] M232 W/Axiom MFD's - no video - Chuck - Raymarine - Moderator - 03-30-20 12:19 PM
Welcome to the Raymarine Forum Nick,
It is recommended that the power and ground be inspected from the camera through to breaker panel and ground to ensure that all connections are tight and free of corrosion. Should any inline fuses be installed in the camera's power circuit, then these too should be inspected. If no issues are found, then please indicate whether the system include a Joystic Control Unit. Alternatively, the MFDs may be the only means of interacting with the camera. Finally, has the camera been interfaced to a network switch or directly to the MFD?