GoTo Waypoint and Follow Route commands not accessible on a/c/e/eS/gS-Series MFD - Printable Version +- Raymarine forum (http://forum.raymarine.com) +-- Forum: Raymarine Forums (/forumdisplay.php?fid=1) +--- Forum: Multifunction Displays (/forumdisplay.php?fid=120) +--- Thread: GoTo Waypoint and Follow Route commands not accessible on a/c/e/eS/gS-Series MFD (/showthread.php?tid=133) |
GoTo Waypoint and Follow Route commands not accessible on a/c/e/eS/gS-Series MFD - Chuck - Raymarine - Moderator - 01-19-16 10:25 AM GoTo Waypoint and Follow Route commands not accessible on a/c/e/eS/gS-Series MFD GoTo Waypoint and Follow Route navigational commands will be blocked if any of the following conditions exist: - The MFD is not receiving a GPS position FIX ... check the GPS Status Dialog for the FIX Status - A MOB event has been triggered ... one may verify this by examining the contents of the Waypoint Info Databar/Databox/Data application data item or by displaying the CDI Data Panel. Should the destination waypoint name listed be MOB, then a MOB has been triggered. A MOB may be cleared by holding the WPTS/MOB button pressed for approximately 3 seconds. - The MFD is currently navigating to a waypoint, cursor position, or following a route .. one may verify this by examining the contents of the Waypoint Info Databar/Data application data item or by displaying the CDI application. Use the MENU->NAVIGATE->->STOP GOTO / STOP FOLLOW to cancel navigation - A data loop exists (typically due to an incorrect installation or incompatible NMEA 0183 device) ... addressing the installation, disconnecting, or powering off incompatible device is required. RAYFAQ# |