Raymarine forum
RF drain wire on power cords - Printable Version

+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: General Discussions (/forumdisplay.php?fid=2)
+--- Thread: RF drain wire on power cords (/showthread.php?tid=559)

Pages: 1 2


RE: RF drain wire on power cords - scoffer - 04-13-16 03:53 PM

OK, thank you for that information. I haven't been able to locate the bonding cable as of yet on my boat, but I presume it has one. One thing I did notice is there appears to be a grounding wire tied to the bolts for the fuel fill where it comes through the hull, which is next to the access panel for electronics / back side of the dash. Would it be possible to tie my RF drains in to that wire and achieve the required bonding / grounding, or is that not recommended?


RE: RF drain wire on power cords - Chuck - Raymarine - Moderator - 04-13-16 03:58 PM

It is not recommended that you do as you have suggested. Should your boat have a bonding cable, then it would likely be connected to a bonding plate. You may want to consider searching from the direction of the bonding plate.


RE: RF drain wire on power cords - scoffer - 04-13-16 04:10 PM

OK, I will keep looking for the bonding plate. Thanks for your help Chuck.


RE: RF drain wire on power cords - Chuck - Raymarine - Moderator - 04-14-16 08:22 AM

You're welcome.