+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Product Selection Assistance (/forumdisplay.php?fid=124)
+--- Thread: [CA] [CA11] autopilot (/showthread.php?tid=7009)
[CA11] autopilot - David Fice - 12-04-18 03:08 AM
I am attempting to put an autopilot on my C-Dory 22. If I install an Octopus Type S wheel, what will I need to make the connection to my Axiom to complete the set up. Here is what I have come up with....
EV Sensor Core and the ACU-100, does the Axiom act as the control head?
If so I think this would be the connection...
The EV Sensor connects to both the Axiom and the ACU-100 (two cables come out of it?) and the ACU-100 connects to the Octopus motor drive wheel.
Does this sound correct?
Thanks!
RE: [CA11] autopilot - Chuck - Raymarine - Moderator - 12-04-18 09:40 AM
Welcome to the Raymarine Forum David,
I too own an Octopus Drive for my powerboat ... in my case a Type R. The Type R and Type S drives are fundamentally the same with regard to their ACU requirements ... in this case an ACU-200. The ACU-100 and ACU-150 do not feature controls for the drive's clutch. Accordingly, it would be recommended that a T70156 EV-200 Power be purchased for use with your Octopus Type S Drive. A powered and properly terminated SeaTalkng / NMEA 2000 backbone will be constructed from SeaTalkng networking components. The ACU-200, EV-1 CCU, p70RS Autopilot Control Head, and MFD will each be interfaced as an individual spur to the aforementioned backbone. The MFD's NMEA 2000 socket may be found on the MFD's Power / NMEA 2000 Cable.
RE: [CA11] autopilot - David Fice - 12-06-18 07:04 AM
Thanks Chuck,
I think I've got it but I have a few more questions.
When you say "A powered and properly terminated SeaTalking/NMEA 2000 backbone" How do I properly terminate the NMEA cable?
My other question concerns grounding. I don't understand what an RF ground point is and what a drain conductor (screen) is.
The electric system on the C-Dory is minimal, should I run a separate supply from the battery to the ev-200 and then power the back bone from the ev200 and from the backbone power the displays? Will the drive unit (octopus) need a separate power supply?
Thanks,
Dave
RE: [CA11] autopilot - Chuck - Raymarine - Moderator - 12-06-18 10:26 AM
David,
Q1. When you say "A powered and properly terminated SeaTalking/NMEA 2000 backbone" How do I properly terminate the NMEA cable?
A1. Termination simply involve installation of one SeaTalkng Termination Plug in each of the backbone's two end sockets. More information concerning SeaTalkng / NMEA 2000 Networking may be found with the SeaTalkng Reference Manual. Although a bit dated, the overwhelming percentage of the information contained therein remains valid.
Q2. My other question concerns grounding. I don't understand what an RF ground point is and what a drain conductor (screen) is.
A2. Please click here to view a FAQ addressing this subject.
Q3. The electric system on the C-Dory is minimal, should I run a separate supply from the battery to the ev-200 and then power the back bone from the ev200 and from the backbone power the displays? Will the drive unit (octopus) need a separate power supply?
A3. Please click here to view a FAQ addressing this subject.