Raymarine forum
[TG] [TG11] Lighthouse 3 Units of measure - Printable Version

+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Multifunction Displays (/forumdisplay.php?fid=120)
+--- Thread: [TG] [TG11] Lighthouse 3 Units of measure (/showthread.php?tid=8096)



[TG11] Lighthouse 3 Units of measure - Chris.au - 05-01-19 05:39 AM

I have upgraded my system (eS98 and Axiom Pro 9) to Lighthouse 3.
One of many issues I have is the setting of measurement units. I have selected NM and metric measures, however, many measurements are still reported in Feet, e.g. Arrival Distance, Minimum safe height, minimum safe width, Chart Range in feet if less than 1NM, alarm settings, AIS ship data and more. With Lighthouse 2, I could set metric measurements and ALL measurements were reported in metric - NO measurements were reported in feet. I have searched all menus to see if I have missed something. The only opportunity to set Units of Measurement appears to be via the Dashboard settings menu, section 12.4 of the Lighthouse 3.9 Advanced Operation Instructions 81370-11. Clearly, this is not a global units setting switch since many units are stuck on feet.


RE: [TG11] Lighthouse 3 Units of measure - Tom - Raymarine - Moderator - 05-01-19 11:03 PM

Hello Chris,

There are separate unit selections for horizontal and vertical distances. The horizontal is controlled by 'Distance Units', the vertical (e.g. minimum safe height) by the Depth unit selection below this. For horizontal distances the default is NM but what you need is 'NM & m'. On my test system, when I set Distance=NM&m and Depth=m, all of the distances you mention are shown in metres.

If you're still having problems, possibly your unit selections are being over-ridden from outside by another device. Can you confirm what version of software your eS is running: it is definitely 3.9? You can see this in Home > Settings > Getting Started.

Regards,
Tom


RE: [TG11] Lighthouse 3 Units of measure - Chris.au - 05-07-19 06:19 AM

Hi Tom, Thanks for the reply. Setting the distances to NM & m fixed the problem. It's not as explicit as simply choosing Metric or Imperial, but maybe there is a reason for the choices they have made.
Regards,
Chris


RE: [TG11] Lighthouse 3 Units of measure - Chris.au - 05-09-19 11:39 PM

Hi Tom,
Setting the horizontal Units to NM & m fixes the problem - all metric now.
Thank you.
Chris


RE: [TG11] Lighthouse 3 Units of measure - Tom - Raymarine - Moderator - 05-13-19 12:06 AM

Very good Chris. In the Americas, NM and feet is the preference I believe, so we try to suit everybody where possible.

Regards,
Tom