[CA] [CA11] No depth data on Seatalk NG, shows up fine on nmea 2000 connected devices - Printable Version +- Raymarine forum (http://forum.raymarine.com) +-- Forum: Raymarine Forums (/forumdisplay.php?fid=1) +--- Forum: Networking / System Integration (/forumdisplay.php?fid=21) +--- Thread: [CA] [CA11] No depth data on Seatalk NG, shows up fine on nmea 2000 connected devices (/showthread.php?tid=9088) |
[CA11] No depth data on Seatalk NG, shows up fine on nmea 2000 connected devices - Dustdevil - 07-30-19 09:20 AM Hi Folks, I'm finishing an install of i50 instruments (wind, speed/depth tridata, EV-200 AP) all networked together via Seatalk NG, with an ITC-5 handling the depth, speed/temp and wind wand. There is a spur cable out to a nmea 2k backbone that exchanges info with a Vesper AIS and Garmin plotters. The issue i'm having is that depth will not transmit through the Seatalk connected devices, but shows up on the Garmin network just fine. i swapped for a known good depth instrument through the network with no joy. I wired the transducer to the depth directly and connected through the ITC-5, and the instrument would read depth, but the Seatalk network devices all still showed 3 dashes. When wired as intended the ITC-5 shows a green steady LED for the depth transducer. Bypassing the ITC-5 with the transducer connections verifies the transducer working. I've disconnected the nmea 2000 spur to see if it's a terminator issue with no change as well. Ideas? RE: [CA11] No depth data on Seatalk NG, shows up fine on nmea 2000 connected devices - Chuck - Raymarine - Moderator - 08-02-19 10:52 AM Welcome to the Raymarine Forum Dustdevil, Please click here to view a FAQ addressing this subject. RE: [CA11] No depth data on Seatalk NG, shows up fine on nmea 2000 connected devices - Dustdevil - 08-12-19 01:04 PM I figured out the issue I was having...The Tridata (and I think any depth/speed/wind etc.) is default set to master in the setup menu. Since i was using an ITC-5, it needed to be set to repeater. RE: [CA11] No depth data on Seatalk NG, shows up fine on nmea 2000 connected devices - Chuck - Raymarine - Moderator - 08-20-19 10:25 AM Dustdevil, I'm glad to learn that issue has resulted from an incorrect configuration of the i50 Tridata's master/repeater settings. Should the system feature an iTC-5, then the system must additionally include an i70S/i70 MFID. The latter is required to calibrate and configure alarms associated with transducers which have been interfaced to an iTC-5. |