[CA] [CA11] gray bar across a-series display - Printable Version +- Raymarine forum (http://forum.raymarine.com) +-- Forum: Raymarine Forums (/forumdisplay.php?fid=1) +--- Forum: Multifunction Displays (/forumdisplay.php?fid=120) +--- Thread: [CA] [CA11] gray bar across a-series display (/showthread.php?tid=9479) |
[CA11] gray bar across a-series display - toddster - 09-07-19 02:00 PM I have an intermittent problem with my A78 MFD that has now become almost constant. A gray bar appears across the middle of the screen that displaces the lower part of the screen by about a centimeter. i.e. the lower part of the image is off the display. At first, this only happened at random times and then went away after a while. Now it appears almost every time I start up the unit, during or shortly after start-up. It renders the main display unusable, although a remote MFD connected via Raynet or an iPad connected via ethernet both display correctly. It does not matter whether external devices are connected or not. The same thing happens. I have reloaded the Lighthouse II software, with no effect. I'm not sure where to go from here... is there a firmware update that I can try? I tried to include a jpg image, but nothing happens when I click "insert into post." RE: [CA11] gray bar across a-series display - Chuck - Raymarine - Moderator - 09-11-19 02:15 PM Welcome to the Raymarine Forum Todd, Unfortunately, the symptom described and shown within your attached photo is indicative of a failure within the MFDs circuitry. It is accordingly recommended that the MFD be sent to Raymarine’s Product Repair Center to be bench checked / serviced. |