[TG] [TG11] Hypervision vs Axiom Comparison - Printable Version +- Raymarine forum (http://forum.raymarine.com) +-- Forum: Raymarine Forums (/forumdisplay.php?fid=1) +--- Forum: Fishfinders (/forumdisplay.php?fid=25) +--- Thread: [TG] [TG11] Hypervision vs Axiom Comparison (/showthread.php?tid=9509) |
[TG11] Hypervision vs Axiom Comparison - longy509 - 09-10-19 08:02 PM Hi just wondering how the element hypervision imaging compares to the axiom pro models and also what are the major differences between the units RE: [TG11] Hypervision vs Axiom Comparison - Tom - Raymarine - Moderator - 09-11-19 09:53 PM Hello longy509, That's a short question with a long answer. Axiom RV and Axiom Pro RVX have the following sounder channels:
Element has the same channels as Axiom RV and adds the following:
RE: [TG11] Hypervision vs Axiom Comparison - longy509 - 09-12-19 11:27 AM Hi Tom thanks for the reply do you have any side by side images to compare the hypervision 1.2Hv to the 350Khz RE: [TG11] Hypervision vs Axiom Comparison - Tom - Raymarine - Moderator - 09-13-19 12:41 AM Personally I don't have any really representative images to hand just now, but here are a couple taken using the original release software, since improved-upon, which should give the idea. The 1.2MHz will give much crisper, more detailed images but only at shorter ranges. Tom [TG11] Element Hypervision vs Axiom Pro Comparison - On Time - 12-12-19 02:10 PM Must replace my old just failed L750 (can you believe it) on my reliable 1998 35' twin 250 EFI CC. Have just enough room for an Element 7HV or possible 9HV. I fish usually 10-50 feet depth and very rarely to about 100'. No deeper with that boat. My essential question: What current device has the best picture? Is it Element Hypervision 1.2Mhz or an Axiom Pro? Or other? We go slow and look for structure. Have an e127 for charting. Will the Element interface well with that unit? RE: [TG11] Hypervision vs Axiom Comparison - Tom - Raymarine - Moderator - 12-16-19 11:58 PM Hello On Time, In those water depths and for structure, I'd go Element. The 1.2MHz channels will go out to about 60' / 20m and then after that you have the 350kHz which is the same as the Axiom range have. Element cannot network to e127 (it has no Raynet port, and currently the only MFD that can be on the same STNG/NMEA2000 network is another Element), but I'd say that that trade-off is probably worth it for the improved sounder image resolution. Regards, Tom |