Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] circuit protection for HS5 network switch

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] circuit protection for HS5 network switch
01-30-18, 04:43 PM (This post was last modified: 01-31-18 04:53 PM by Chuck - Raymarine - Moderator.)
Post: #1
CoastalMarine Offline
Junior Member
**
 		Posts: 8
Joined: Mar 2017
Reputation: 0
[CA] circuit protection for HS5 network switch
The installation manual for the HS5 Network Switch says to be provide circuit protection of an appropriate amount, by I have not been able to find what value fuse to use anywhere. I thought I posted this question last week, but I cannot find any record of it, so I am trying again.
Thank you
Find all posts by this user
Quote this message in a reply
01-31-18, 04:55 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA] circuit protection for HS5 network switch
Welcome to the Raymarine Forum CoastalMarine,

Like the SeaTalkhs Network Switch which it replaced it is recommended that the circuit supplying power to HS5 RayNet Switch be protected with a 2A fuse.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication