Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG] Toggle switch for Depth Transducer ST60+
06-11-18, 05:25 PM (This post was last modified: 06-12-18 06:08 AM by Derek - Raymarine - Moderator.)
Post: #1
[DG] Toggle switch for Depth Transducer ST60+
I'd like to be able to switch the depth transducer on/off without turning off all the instruments.

Ideally I could put a toggle switch on one of the 5 wires running to the depth transducer, but I'm concerned I would damage the output of the ST60+.

I have a ST60+ Tridata connected to S2 SmartPilot and wind instruments.

Is there a safe way to do this?

Thanks!!
Find all posts by this user
Quote this message in a reply
06-12-18, 06:11 AM
Post: #2
RE: [DG] Toggle switch for Depth Transducer ST60+
Hi JYLC48

Thank you for your enquiry.

The preferable way to achieve this is to connect the ST60 depth instrument onto a spur off the general SeaTalk bus, then when depth is not required, turn this spur off by switching the red and yellow cores of the SeaTalk to the Depth instrument.

This is recommended, we advise against switching the transducer lines.

Regards
Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)