Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] e125, HS5, CAM220ip - no communications
01-14-19, 10:29 AM (This post was last modified: 01-16-19 11:06 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] e125, HS5, CAM220ip - no communications
I am unable to see newly installed 2 each CAM220ip on my e125. The CAM220ip cameras are connected to HS5 through CAT6 cable to A80247 adapter. The lights on the HS5 on the camera ports are not flashing. Have sonar connected to same HS5, sonar port lights are flashing and can see sonar on e125. If I connect PC to CAT6 cable, unplugging from A80247 I can see the camera.
Find all posts by this user
Quote this message in a reply
01-14-19, 06:33 PM (This post was last modified: 01-16-19 11:07 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] e125, HS5, CAM220ip - no communications
Welcome to the Raymarine Forum jamoritz,

Please click here to view a FAQ addressing how one may determine the versions of software which are installed within one's products. Which version of LightHouse software is presently installed within your MFD?
Find all posts by this user
Quote this message in a reply
01-15-19, 08:15 AM (This post was last modified: 01-16-19 11:07 AM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [CA11] e125, HS5, CAM220ip - no communications
Chuck,
Used a CAT5 tester and found that I was losing connection on two pins if I flexed the CAT5 at the connector going to the HS5. Replaced the CAT5 cable and system works good now. Thank you for your help
Find all posts by this user
Quote this message in a reply
01-15-19, 10:16 AM
Post: #4
RE: [CA11] e125, HS5, CAM220ip
You're welcome.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)