Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] virage total st 4000 tiller après reparamétrage
04-08-19, 02:11 PM (This post was last modified: 04-09-19 03:05 AM by Derek - Raymarine - Moderator.)
Post: #1
[DG11] virage total st 4000 tiller après reparamétrage
hello, excuse me to not discribe my probleme in English but with tehnical English it's hard ,thank you for your respons
J'ai du changer mon st 4000 qui s’était cassé au niveau de l'articulation.
Il ne fonctionnait pas pas bien et j'ai voulu le reparamétrer sur l’écran P 70 .
j'ai suivit la procédure ,mais je dois oublier ou ne pas faire une action nécessaire.
Lorsque je sors avec mon bateau et que j'enclenche auto le pilote met la barre à bâbord totalement ou a tribord ( j'ai essaye plusieurs fois après avoir modifier des paramètres ) et le bateau tourne en rond jusqu’à ce que l'alarme de butée sonne...

matériels
P70
A60
ST 4000+
Convertisseur sang
ACU 100
EV 1
Actsense NGW1 STNG

thank you ...
Find all posts by this user
Quote this message in a reply
04-09-19, 03:13 AM
Post: #2
RE: [DG11] virage total st 4000 tiller après reparamétrage
Hi POURTIER

Thank you for your enquiry.

the problem that you have is that you cannot keep the ST4000 control unit in the same network as your new EV1 and ACU units. The ST4000 control unit is a self contained control unit+computer + drive unit controller, whereas the EV1 is the new evolution autopilot heading sensor and computer combined, the ACU is the drive unit controller.

You will need to remove the ST4000 control unit from the system and it cannot be used.

You should then check the STng system connections between the p70, EV1 and ACU. The A60 presumably is connected to STng via the Actisense converter?

Once the ST4000 control unit is disconnected, you can then complete the correct calibration of the autopilot.

Regards

Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)