The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] SeaTalk1 to NMEA 2000
01-03-20, 06:41 PM (This post was last modified: 01-06-20 04:21 PM by Chuck - Raymarine - Moderator.)
Post: #1
[TG11] SeaTalk1 to NMEA 2000
I'm a new owner of a 2005 Beneteau that has an existing Raymarine Seatalk1 Network.

All the instruments are running through the Seatalk1 Network, I would like to add a NEMA 2000 Network for two way communication adding a NEMA 2000 AIS transponder and a NMEA 2000 Ethernet Gateway to send all the data to an onboard router.

The router will have Internet and wired webcams connected on the local network and if I understand correctly I can then share the NEMA 2000 and SeaTalk1 data over the Router's Wifi to laptops and tablets?

Does the attached diagram look correct?

I'll need power for both the SeaTalk Converter and the NMEA 2000 Network?

Thanks, Neil


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[TG11] SeaTalk1 to NMEA 2000 - nsmi - 01-03-20 06:41 PM
RE: [TG11] SeaTalk1 to NMEA 2000 - nsmi - 01-06-20, 03:51 PM
RE: [TG11] SeaTalk1 to NMEA 2000 - nsmi - 01-07-20, 09:03 AM
RE: [TG11] SeaTalk1 to NMEA 2000 - nsmi - 01-19-20, 06:46 PM
RE: [TG11] SeaTalk1 to NMEA 2000 - nsmi - 01-20-20, 07:17 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)