Post Reply 
 
Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] I50 Depth and Fish Finder
01-14-20, 09:19 AM
Post: #12
RE: [CA11] I50 Depth and Fish Finder
Andy,

Diagram comments:
- the SeaTalk connection between the i60 and ST4000 should be removed or a data loop will be created. The ST4000 will receive wind data from the SeaTalkng / NMEA 2000 backbone via the NMEA 0183 data bridge.

Q1. is will the original wind vane / transducer that comes with the original ST60 wind instrument work with the newer I60 wind instrument. I have the vane / transducer for I60 but may not be able to get up the mast to replace just yet. I am hoping the original cable will work.
A1. The wind transducer specified for use with the i60 Wind instrument and iTC-5 is identical to that which had been specified for use with the legacy ST60/ST60+ Wind instrument and ST70 Speed Pod. Should the currently installed wind transducer look like that pictured below and should it be operational, then it would be recommended that it remain in place and that the Wind transducer supplied with the i60 Wind instrument be kept as a spare.

[Image: wind.jpg]
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] I50 Depth and Fish Finder - Chuck - Raymarine - Moderator - 01-14-20 09:19 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us