The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] RD424HD / E120 Failed soon after install
01-26-20, 06:01 AM (This post was last modified: 01-27-20 04:44 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] RD424HD / E120 Failed soon after install
Puzzling performance from a new RD424 installation

Installed a new RD424 HD with cable on a dual E120 MFD Network.
Installed update 5.69. (From Radar Marine)
Performed reboot and master reset on both MFDs

RD424 powered up and ran immediately on both MFDs. Targets/ power up and down/ range / gain / see targets / all appeared to be well.

Got a call about an hour later from the to say RD424HD would not run. NO data source was reported

DC power to dome connector OK @ 12.8 vdc
DC power to breaker @ 13 VDC
Noted Activity on Switch port
Swapped a switch port
All other network devices work

It was necessary to cycle Radar breaker to start "powerup" process Softer key for Scanner was seen after a delay the "power button / TX" dialog was seen but pushing that soft key would not cause radar to Transmit and the softkey would disappear after some 15 seconds or so.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] RD424HD / E120 Failed soon after install - JoeZInc - 01-26-20 06:01 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)