Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] RD424HD / E120 Failed soon after install
01-27-20, 04:51 PM
Post: #2
RE: [CA11] RD424HD / E120 Failed soon after install
Welcome to the Raymarine Forum Joe,

I would recommend that a second Factory Reset be performed to the MFDs. Should the second reset fail to correct the problem, then a possible cable failure may be fault isolated by
- opening the radome
- unplugging the Ethernet cable from the radome core
- connecting the radome core to the network switch using a commonly available CAT5/6 patch cable.

Should the problem persist, then it would unfortunately appear that the radome core has suffered an out of box failure, necessitating that it be replaced or sent to Raymarine’s Product Repair Center to be bench checked / serviced.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] RD424HD / E120 Failed soon after install - Chuck - Raymarine - Moderator - 01-27-20 04:51 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)