[DG11] Test of new ST60 Wind PCB

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[DG] [DG11] Test of new ST60 Wind PCB

02-11-20, 02:04 PM (This post was last modified: 02-11-20 04:00 PM by Chuck - Raymarine - Moderator.)

Post: #1

earlinks Offline

Junior Member

Posts: 2
Joined: Feb 2020
Reputation: 0

[DG11] Test of new ST60 Wind PCB

After replacement of the old PCB in in my ST60+ Wind Mast Head Unit(MHU), I wanted to test it before new season.
I do so as describe in this post: http://forum.raymarine.com/forumdisplay.php?fid=117
I powered it up separately with 8V and measured the Voltage of the yellow to black (Ground) wire. But it switches only from 0V to 2.5 V while slowly turning the anemometer.
Will the instrument work with this or have I to reply to the seller?
Thank you for answer
Juergen

« Next Oldest | Next Newest »

Messages In This Thread

[DG11] Test of new ST60 Wind PCB - earlinks - 02-11-20 02:04 PM

RE: [DG11] Test of new ST60 Wind PCB - Derek - Raymarine - Moderator - 02-14-20, 11:04 AM

RE: [DG11] Test of new ST60 Wind PCB - earlinks - 02-15-20, 05:14 AM

RE: [DG11] Test of new ST60 Wind PCB - Derek - Raymarine - Moderator - 02-17-20, 07:18 AM

User(s) browsing this thread: 1 Guest(s)