Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Connecting SeaTalk1 and NMEA2000 using the SeaTalk Converter
07-17-16, 01:44 AM (This post was last modified: 07-18-16 08:29 AM by Chuck - Raymarine - Moderator.)
Post: #9
RE: Connecting SeaTalk1 and NMEA2000 using the SeaTalk Converter
I have a similar problem. I am creating a Seatalk ng network with new instrumentation and MFDs. I will be using a DeviceNet cable for a NMEA 2000 connection to an AIS transponder that will make GPS/AIS data outputs to other NMEA 1083 devices. I have an ST6001 pilot controller which uses Seatalk 1 that I would like to link. I could do this with a NMEA1083 output to the transponder. However, I have purchased a controller kit which includes a Seatalk 1 to Seatalk ng cable.
This cable has modular connectors and the ST6001 uses Seatalk 1 connections with wire ends. In order to use the Seatalk 1/ng cable, will it work to clip off the Seatalk 1 connector and strip the wires for connections?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread

Forum Jump:


User(s) browsing this thread: 1 Guest(s)