Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
No Track with Garmin MFD after Updating Evolution AP
06-21-17, 11:04 AM (This post was last modified: 06-21-17 02:06 PM by Chuck - Raymarine - Moderator.)
Post: #29
RE: No Track with Garmin MFD after Updating Evolution AP
cjwynne,

It is recommended that you command the MFD to go to a cursor position or single waypoint which located well outside of the waypoint arrival circle's radius which has been configured within the MFD. While then moving in the direction of the waypoint, can you command the autopilot into Track mode?

If not, then it is recommended that you verify that all of the system's NMEA 2000 devices (Raymarine and third party) have each been updated with the latest available software updates. It is further recommended that you verify that only one source of power has been provided to the NMEA 2000 backbone (for ACU's capable fo supplying power to a SeaTalkng / NMEA 2000 backbone, it is recommended that its SeaTalkng power switch be moved to the OFF position and that the backbone be powered from a single power insertion spur socket located at the approximate midpoint of the backbone's LEN load.

If so, and the problem persists, then please respond with a diagram (hand drawn will suffice) of your system.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: No Track with Garmin MFD after Updating Evolution AP - Chuck - Raymarine - Moderator - 06-21-17 11:04 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)