The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
A/P works but steering stuck when I go to Standby
07-09-16, 09:34 AM (This post was last modified: 07-12-16 02:35 PM by Mark - Raymarine - Moderator.)
Post: #1
A/P works but steering stuck when I go to Standby
Hydraulic Linear , Type 2 coupled with p70 controller and a SPX-30 course computer. Unit works fine in Autopilot mode but steering is almost impossible to move in Standby. I suspect the clutch solenoid for the bypass valve mounted on the ram. Are there any special issues or concerns in removing the clutch assembly? I am in Bocas del Toro, Panama so no Raymarine tech support is available and I do not want to damage anything. If it matters, the E12207 Type 2 hydraulic linear drive is coupled to the p70 controller and SPX-30 SmartPilot course computer.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
A/P works but steering stuck when I go to Standby - Gordon Wellwood - 07-09-16 09:34 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)