Thread Closed 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Saving Default Power Up Settings on e97 with V17 S/W
08-31-16, 01:07 PM
Post: #2
RE: Saving Default Power Up Settings on e97 with V17 S/W
Welcome to the Raymarine Forum Bill,

The subject problem was first detected in conjunction with the R16 software update and then duplicated in the R17 software update. In a nutshell, the non-Data Master MFDs will default all waypoints to SHOW when switched OFF and then ON again. This problem does not occur on the Data Master MFD. A problem reports has been logged to seek correction of this problem within a future a/c/e/eS/gS-Series MFD software update. To work around this issue, it will be necessary to command the Chart applications pages/panes of the non-Data Master MFDs to HIDE the waypoints each time that the MFD's are switched ON.
Find all posts by this user
Thread Closed 


Messages In This Thread
RE: Saving Default Power Up Settings on e97 with V17 S/W - Chuck - Raymarine - Moderator - 08-31-16 01:07 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)