Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
E125 V17.45 Routes Reverse
08-09-16, 09:41 AM
Post: #1
E125 V17.45 Routes Reverse
I have several routes in my E125 which are name appropriately as (From)-(To). for example Brist-Cutty for Bristol to Cuttyhunk. Before upgrading to V17.45 if I went from Cuttyhunk to Bristol, I'd call up that route and run it in reverse. After the upgrade, when I tried to run a route, I'd sometimes get the route correctly but sometimes I'd get the reverse.
This happened several times and I have tried to figure this out. I checked my saved routes and found that if I tried to run the route in reverse, the saved route would reverse. I know that I can call up a route under My Data and reverse it. The behavior occurred when I tried to actually run a route in reverse. As a workaround, I would run a route, check the order of the route. If it was backwards I'd stop the route, run it in reverse and check again. Previous version of the firmware did not exhibit this behavior.
There was another anomaly noticed one time. When in the middle of a route, I shutoff the E125 while starting my engine. I then would call up the route and advance the waypoints until I got back to where I was before shutting off the E125. One one occasion, the waypoints advanced in the direction of the route for several points and then reversed. Unlike the behavior noted in the previous paragraph, I have not been able to duplicate this.
At this time of these incidents, the following equipment was running; E125 V17.45-00403,RS130 V2.20; ITC-5 V 1.12; EV1 V2.17, I70 (x4) V3.05, P70 V3.05, ACU-200 V2.17 & Ray260 VHF V2.03. All were powered up and updated with the V17.45 update except for the VHF which was updated around June 2014 by Raymarine.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
E125 V17.45 Routes Reverse - Ron.Ricci@1968.usna.com - 08-09-16 09:41 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us