Raymarine forum / Raymarine Forums / Autopilots v / Networking

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Networking
08-23-16, 10:29 AM (This post was last modified: 08-23-16 10:30 AM by Chuck - Raymarine - Moderator.)
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: Networking
Welcome to the Raymarine Forum Dkdoyle,

It is not possible to use a SeaTalk to SeaTalkng Cable for the purpose specified. This cable is exclusively designed to permit interfacing products having a SeaTalkng communications interface which has additionally been designed to support SeaTalk communications (ex. i70, p70, p70R, i50, i60). If installing a powered and properly terminated SeaTalkng backbone, then a SeaTalk to SeaTalkng Converter (updated with v2.1 or later software) would need to be installed as a component of the backbone. The un-powered SeaTalk bus interfacing the Raystar 125 and C80 to one another would be in turn be interfaced to the yellow SeaTalk socket of the SeaTalk to SeaTalkng Converter.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Networking - Dkdoyle - 08-19-16, 09:18 PM
RE: Networking - Chuck - Raymarine - Moderator - 08-23-16 10:29 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication