Replacing all electronics

[wrandy]

Chuck,
Thank you for the post. I thought that there was only to be one 12v supply to the Seatalkng network and that included the displays. If I understand your post I now need to add 12v supplies for each of the displays. If I had realized that I would have pulled the power wires when I pulled the Seatalkng and the Ethernet cables. Should they each be on a separate 5 amp breaker?

In the helm pod is it acceptable to put the three instruments in series and then into the display and the display to the backbone with a spur cable or should I use the 5 port connector that I am showing?

I have searched the internet for the 1/8" female spade connectors but have only found 1/4" so far. I will continue looking.