Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Yamaha command link engine ID problem
11-28-16, 09:18 AM
Post: #10
RE: Yamaha command link engine ID problem
Now I have a new issue. When I go through the engine ID procedure the ECI-100/mfd identifies both engines fine and I get a big green check mark. Then when I go to the engine data page I'm only seeing the starboard engine.
The first couple of times I went through the procedure I saw both engines for a few seconds and then the port enginge data disappeared.
This started right after I updated the ECI-100 to the latest software.
I'm thinking that the ECI-100 may have stopped working properly.
What now?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Yamaha command link engine ID problem - Bhngh - 11-28-16 09:18 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)